Average Reviews:
(More customer reviews)Mic Clip threads bottom out against the black bar on the brass screws at rotations other than 90 degrees to the bar. Adjustments by turning brass threaded "thumb screws" out don't matter. It's like turning two nuts on a bolt to lock them. Turning the bolt will not change where the nuts lock because the bolt turns the same in each nut(mic clip and the black bar). If this unit had brass screws that had a space after the brass screw was all the way screwed into the black bar they would work well but they don't. The brass screws bottom out and tighten up against the black bar, So... a shim (one or two small pieces of electrical tape under each clip allow for clips to "bottom out" at 90 degrees to horizontal bar and then life is good. It was either a design or a manufacturing flaw. It's a shame because the picture of the unit leads one to assume the brass "Thumb" screws would tighten into the mike clip and not the black bar of the unit. The black bar should be "pinched" between the mike clip and the bottom of the brass "thumb screw". Oh well....
Click Here to see more reviews about: Musician's Gear Double Microphone Attachment (Standard)
Click here for more information about Musician's Gear Double Microphone Attachment (Standard)
0 comments:
Post a Comment